Tech 21 SansAmp GT2 Tube Amp Emulator Pedal Bundle with 2 Patch Cables and Power Supply

“Architecturally” create your own rig in seconds. You can easily achieve the most sought-after tube amp sounds, and entirely new ones as well. Choose amplifier type, modification and speaker cabinet/mic placement configurations. You can easily mix and match specific sound characteristics in ways that would otherwise be physically improbable, probably impractical and definitely not cost effective. The GT2 is a truckload of great amps in a single, simple pedal.Character switches include:MIC: Classic = distant miking without ambiance. Center = close miking at the center of a speaker cone.Off-Axis = close miking at the edge of a speaker cone.MOD: Clean, which gives you a stock tube amp set-up.Hi Gain, which gives you an extra gain stage, as if you were to install an additional 12AX7 tube in the pre-amp section.Hot-Wired, which gives you a scooped-out midrange for a sizzling, over-the-edge quality.AMP: Tweed = Fender-styleBritish = Marshall-styleCalifornia = Mesa Boogie-styleKnob controls fine tune the sound for any application. DRIVE adjusts the overall amount of gain and overdrive. LEVEL adjusts the output level, without altering any tonal characteristics. The on-board active tone controls compensate for the limited range of guitar speaker cabinets and combos, offering optimum control in any situation.

• An all-purpose, all-analog tube-amp emulator for guitar, bass, and other instruments
• Equipped with 3 x 3-way voicing switches, 2 shelving EQ bands, and independent gain and drive controls to give you an incredible range of tone
• Independent gain and drive controls let you hit the preamp emulation as hard as you like and push the power amp emulation separately for a wide range of clean and overdriven tones
• High- and low-frequency shelving equalizer bands give you additional general tone-shaping options
• Bundle includes 2 patch cables and 9 volt power supply